Contour Enthusiasts Group Archives Forums Modifications General Mods New General Mods Suggestion Box

This is the area to provide suggestions for How-tos and ways to improve the General Mods forum.

Suggestions for an FAQs that would not fall into any of the other Forums - Duratec Performance, Zetec Performance, Aesthetics, etc.

If you would like to do a How-to, please post here w/ what How-to you will be doing.

Try to include what tools are needed/used, what should be purchased (parts, liquids, etc.), time needed, etc.

PM when How-tos are ready - I'll give an email address.

Please note that this is not the area to discuss Mods - please, start your own thread!

If a reply is made that is not a suggestion (or an agreement of suggestion) it will be deleted.

I think a how to for the gauge pillar would be nice.

Most people do the air/fuel, volts, and oil pressure. I searched enough and for a mechanically declined person these can be tricky.

Would this how to be useful? If not i won't even bother...

yes, please do as i have seen the results of a botched installation attempt.... to the tune of $1800 in replacement interior/ engine parts.... And i dont know about you, but i can think of better things to spend that much money on.