Why not take the UIM off, take it to the car wash and spray the sh*t out of it. I purchased an extra UIM a while back and did this, and it seemed to work great...everything came loose and it looked great...I never installed it due to a mod gone bad, but am looking to clean the UIM on my car this weekend...I have searched, but have not seen/heard of anyone doing it, and the reasons to or not to do it...thankx
~Matt
if the pressure is too high on the sprayer you can strip off the paint on the outside and inside of it, can be even worse if you have an SVT
If that's it, I'm not worried about the paint, and no svt
so it's a go! thankx
yeah there really should not be a problem with doing that, just make sure the psi is not too high and you should be safe
Just 10 minutes ago I just got done cleaning my LIM, my Heads, my fuel rail, and my injectors, and I just stared at my UIM wondering how the [censored] I was going to pull it off. Will this car wash thing really work? Ill do it tomorrow!
I can't see a problem with it, as long as you use rinse water and not soap...i purchased an extra UIM a while ago, took it to the car wash and sprayed the h*ll out of it, inside and out. it looked new, as far as I could see, and seemingly has no problems (although i never installed it). Will I need a new LIM UIM gasket for ust an UIM cleaning? I don't think I have the technical experience or tools to do the lower. What about a new TB UIM gasket? STOP, DON"T SHOOT, I'm going to the how to now, but wanted to reply...thankx
~Matthew