Well it seems my rotor is going to be a huge PITA to get off. I went ahead and got a gear puller that will probably wourk with the rotors (it fits up and everything) its 3 teird and im HOPING it dosent warp it at all.

Now i need to know if its safe to put the middle part (the one tong that works the opposite way) pushing into the axle.. where the axle nut usually is. Can i put any pressure on that, or is it bad for the axle??

nm, got it.

Make sure that you apply some anti-sieze between the hub and rotor so that it will come apart easier next time.