Overheating problem. - 08/18/06 05:38 PM
Well it all started with a 99 3.0 Duratec motor that we dropped into my '95 Contour SE.
Everything went well, the motor ran fine.
We had a electric waterpump off a Boss Hoss BBC motorcycle.
The car would run up to the M and the fans would kick on and lower itself.
At first if you would let it sit and idle it would be fine.
But if you took it for a couple mile spin, pull it back in the shop and let it idle the temp would raise above M and keep going towards red.
Once the cooling fans would kick in you know it would be hell breaking lose, the overflow resivore would expand w/ the coolant eventually pushing it out the cap of it and the temp gauge would still be elevating towards red.
Well we thought this was a head gasket/cracked head problem because we replaced one of the heads and head gasket in order to get the top motor mount in.
So we pulled the motor and got another '99 motor.
This time we pulled both heads, inspected them, replaced both headgaskets and all other gaskets involved with that.
We got the motor put in, everything was running smooth until last night it did the same thing, after about a 2mile drive or so, came back to the shop and left it idle and the fans spun and then it started overheating.
Please dont sit here and point the finger at me because I did a pre '01 swap.
i know theres some who did swaps w/o the 01+ motors..
Im just looking for valuable information, no flame wars.
-jared
Everything went well, the motor ran fine.
We had a electric waterpump off a Boss Hoss BBC motorcycle.
The car would run up to the M and the fans would kick on and lower itself.
At first if you would let it sit and idle it would be fine.
But if you took it for a couple mile spin, pull it back in the shop and let it idle the temp would raise above M and keep going towards red.
Once the cooling fans would kick in you know it would be hell breaking lose, the overflow resivore would expand w/ the coolant eventually pushing it out the cap of it and the temp gauge would still be elevating towards red.
Well we thought this was a head gasket/cracked head problem because we replaced one of the heads and head gasket in order to get the top motor mount in.
So we pulled the motor and got another '99 motor.
This time we pulled both heads, inspected them, replaced both headgaskets and all other gaskets involved with that.
We got the motor put in, everything was running smooth until last night it did the same thing, after about a 2mile drive or so, came back to the shop and left it idle and the fans spun and then it started overheating.
Please dont sit here and point the finger at me because I did a pre '01 swap.
i know theres some who did swaps w/o the 01+ motors..
Im just looking for valuable information, no flame wars.
-jared
