zetec head flatness spec - 07/13/06 07:59 PM
does anybody know the head flatness spec for a 97 zetec head? my ford spec is definetely messed up and cannot be right so yea. thanks alot
Steve.
Steve.
Re: zetec head flatness spec - 07/13/06 10:48 PM
My '96 shop manual says...
Cylinder Head .025/25 x 25 0.050/150 x 150
Cllinder Block 0.05/.52 0.076 Overall 150 x 150
That is EXACTLY how it reads from my manual. I'm not sure how to interpret that info, but that's what it says.
I hope that helps.
BP
Cylinder Head .025/25 x 25 0.050/150 x 150
Cllinder Block 0.05/.52 0.076 Overall 150 x 150
That is EXACTLY how it reads from my manual. I'm not sure how to interpret that info, but that's what it says.
I hope that helps.
BP
Re: zetec head flatness spec - 07/13/06 11:02 PM
My '96 CD-ROM manual says the exact same as above.
BUT
My '00 CD-ROM manual says something completely different...
HTH,
BP
BUT
My '00 CD-ROM manual says something completely different...
HTH,
BP
Re: zetec head flatness spec - 07/14/06 11:42 AM
Originally posted by ButtonPuncher:
My '96 CD-ROM manual says the exact same as above.
BUT
My '00 CD-ROM manual says something completely different...
HTH,
BP
is that for a 00' zetec? because the VCT zetecs and the silvertops were considerably different engines.
Re: zetec head flatness spec - 07/14/06 07:33 PM
Yes, the table was from my '00 CD-ROM manaul.
I would think it's still valid data. It's still the same cast iron block and aluminum head. I could put a VCT head on my non-VCT block. AFIAK, they didn't change any oil or coolant passages.
Heck, I'm planning on running the FRPP Focus head on my '96 block.
BP
I would think it's still valid data. It's still the same cast iron block and aluminum head. I could put a VCT head on my non-VCT block. AFIAK, they didn't change any oil or coolant passages.
Heck, I'm planning on running the FRPP Focus head on my '96 block.
BP