Any recommendations on pressure for 225/50/16 victoracers? I have roush springs and rear sway bar, within stock alignment specs, no aftermarket camber plates.
I would say start with about 40-45 front and 35ish rear and adjust from there based on surface and feel.
Those pressures seem kinda high for those tires. PM SVTFern as he uses Victoracers all the time.
I usually run 38 - 40 on fronts and rears. i have ground controls / konis, 21mm rear bar and far too many other mods to list.
I find the handling of my car to be neutral to almost having a tendancy to oversteer. the car is fast...right Bryan??
My only advice for tire longevity is to rotate them after each session.
i have never taken tire temps so i am not sure if i need to adjust the pressures at this point.
hope this helps.
Fern
BTW Bryan did you send that CD / DVD of Putnam my way?? Has not arrived. Always worry about Customs delays.
thx
I thought you ran lower pressures than that. And yes, Fern = fast! I have been running about 4 - 5 PSI lower on the rears than fronts.
I have been a slacker and have not sent out the video - I will try this week. Did you go to Gingerman last weekend?
I run 40 ft 38 rr on Hoosier R3S04's.
Fern in a blast to ride along with - I was shocked at how much you can do with stock brakes (when he had them).
Fern - you coming to Shannonville?
I will be at Shannonville and will probably be riding on the Avon Tech R tires. Gonna give them a try. Might even try lowering the rear pressures to see what that does.
This time at Shannonville i will see how much better the TCE kit performs.I have been really impressed so far.
See you there.
Fern
cool.... good to see that you are coming along!!