A Few of you will remember that for my casting class I was working on the prototype for a 2 guage autometer 2 1/16" guages to sit in the radio DIN sized opening in any dash. Well The prototype is dont and works perfectly in my MSP. I finished the casting class but had little success with the casting process, some of the walls were just too thin. so now that I am in a plastics class I am thermo forming them out of ABS plastic. I have done 2 so far and the 1st did not turn out well. The second is in my MSP as we speak. The good thing about the ABS is that one side is textured and the other smooth. I can make either side be out. The purpose of this post is to gather interest in purchasing this piece for under $50 shipped.

A gracious CEG member (Kokopellian) will be prototyping the smooth ABS in his MSP as soon as I can get it to him. Ill post up pics of the grained one in the MSP when I get some time in the next few days. Swazo will most likely have a smooth on in a pre98 consol soon as well.


Start a list and include a pm to me about your shipping address and tell me grained or smooth.


Here is a pic or two from my MSP with the original Billit piece painted black.

looks great. i like mods that could have been stock pieces.

But ina tour won't you have to have it not only angled a litte to the drive but up as well if this is to replace where the HU sits.

~Alex

makes me want to switch back to the pre98 center console

I want 2 smooth versions for sure, just let me know what I need to do. I've been hoping this GB was going to happen, good job Scot

Originally posted by Horse:

---

Start a list and include a pm to me about your shipping address and tell me grained or smooth

---

List:
Swazo = 2 smooth

your already on the list - local pickup is cheaper