The heater blower switch in my 95 Contour worked fine at all selected modes until last night. The selector switch was stuck at the high position and required a bit of force to move it back to low.I suspect the switch is toast.The blower does work at Lo, and at Med Lo . Will not operate at Hi nor at Med Hi . But.. if the selector is first set at Hi and then moved back to Med Hi, the Med Hi level will work.(please note that the console does not indicate LO, Med Lo etc, just the positions, but you all know that anyway )
I would request verification that its the switch and not the resistor.
Thankyou in advance
