huh? I wasnt understanding about the 50 dollar part. im open ended. All the flanges are hand shimmed in for perfect match to the intake ports. The runner crossectional areas i have are 1.5 1.6 1.62 1.63 and 1.75 lengths are specified upto 7.5 inches (thats the longest that will fit). The plenum on the circular is 98 cubic inches the square plenum will be 126 cubic inches. I will look at putting full roll backs on the trumpets they are worth a couple percent but ill eval that on a dyno.
All the welds are tig and the pieces gaurunteed not to be breakable under normal operating. The flange is a full quarter inch and all metal is 6061 t-6 heat treated alumnium.This is the good stuff no junk here. This is not a show piece its a race piece. I do offer full finishing with leveling of welds and polishing for 200 extra. The base piece is 450. I cut it to your cam and head flow all you have to do is give me the specs I take it from there.
Last edited by Travis; 06/22/04 02:55 PM.
