Originally posted by Derk2000:
I should make this clear:
No matter what UIM you send Extrude Hone, we all get the same final flow numbers.
Not a shabby deal for you SE folks!


Explain how you managed that???

That is completely against their normal policy and routine since one EH run is a specific timed event.
Multiple manifold thicknesses and matching flow rates would make a group buy like this a logistical nightmare for them.


If it is true then that is one hell of a deal and even DH SVT UIM's would almost not be worth buying because you can make any UIM into the best UIM for $300.



I am on the fence of I'll believe it when I see it because that goes against everything I learned from the Extrude Hone themselves. (You are dealing directly with them and not a second source right?)



BTW - my UIM is not just triple honed. It was taken to the limit of the UIM. You will not get that from this group buy I guarantee it.

Hence why it took so long for mine and part of the reason I had to deal directly with EH. I started by going through a second source and that was a HUGE MISTAKE!!! Everything (price, process, etc) they said was completely wrong. (old and ugly story Hindsight is 20/20 they say)

2000 SVT #674 13.47 @ 102 - All Motor! It was not broke; Yet I fixed it anyway.