Originally posted by outkast:
BONE HEAD!



When you go to remove the struts on contours!You must be
very carefull.The tie rod ends,lower ball joint,lower
control arm bushings,CV boot and upper strut mounts
become weak,when doing a stuts.This is why most people
do them all at once.Also be careful when you remove the
shaft from the bearings.I have a special tool for installing
ford axle shafts.Keep in mind that those upper mounts
should be replaced also.The springs may or may not mount
back in the same place,which will cause a rattle when
going over bumps.I hope this info help you.


New Pics of OUTKAST 1!Sept2006