Originally posted by ContourKev:
took my switch apart....
2 plastic connectors broke, the 2 pins in the middle are for the light inside the switch... need a new switch then




???????????

My switch was wired like this (each '.' is a blank space):

x.x.x.x
.-.-.-
x.x.x.x

Two of those '-' were the fog light circuit which I confirmed with a simple continuity test on the switch. Pull out the foggies, 0 resistance. The 'x' were used for other stuff.

There were two small brown wires with misc stripes on the harness plug that were the fog light switch wires, I spliced my aftermarket switch wires in there so my new switch would work like factory. Funny 'cause I didn't have the wiring under the bumper....?


Must be that jumbly-wumbly thing happening again.