I got my hands on an Alpine 7995 cd/mp3 deck (no internal amp, 3 4v preouts). I was replacing a JVC Kameleon so I figured it was a very easy procedure since I already had a a spliced harness. I re-spliced it for the Alpine and now the Alpine won't turn on. I think it isn't getting any power.

I am fairly sure that the wiring is correct from the Ford harness to the Alpine harness.

Got any ideas? I was gonna use a voltmeter tomorrow to check and make sure the wiring had the correct voltages.

Also, the original install had a small cube that had the two power wires, the ignition signal wire and the power antenna wire. The electrical digram shows a switch between two wires and the rest i cant really intrepret. I can upload a copy of the diagram if it helps. I took out the cube from the install thinking it was not important and maybe it isn't.

I will make sure to post pics when it is finished and working.


Have you put in your $0.02 to save contour.org?? Put in what you can spare to keep the site up. Check the General Forum.
~~~~~~
David
* 2k Black SVT on 17" Konig/Yokohama
* MB Quart all around; Alpine 7995, DEI/Alpine amps; Dynomat

Soon to come:
19" HRE 445s under GC/Koni Setup, Custom passive-AWD kit, 2 small Sequential Turbos running low boost, Sequential 6-speed, Widebody Kit, custom black-red chameleon paint; on and on...