Originally posted by MercuryMystik99:
So how long did it take you to do it, and how much did it cost you overall? Ive been very interested in this project.



its been about 11 months now since its been down. Yes, thats a very long time, but thats what happens when its your first time, it mainly only gets worked on saturdays, and stuff needs to be shipped back to be corrected. We had a problem with our Street Flight kit, and we had to send it back and that took about a month all together. Stuff like that just slows stuff down. Its all good now though. Keyser and Keith at Street Flight have been plenty of help.

This project has costed me well over $12,000. It can be done for much less than that, since ive also done mods like custom pistons, upgraded rods, balanced crank, ported and polished heads, quaife, zetec final drive, etc.

Originally posted by ZetecNinja:
you mean you aren't going to atleast take it around the block with the 3L in it?



if the clutch was bled, the axles were in, the new drivers side knuckle and hub was installed, brakes were bled, and wheels were on, then yes i would take it around the block.

Jim Hahn 1996 T-Red Contour SE Reborn 4/6/04 3.0L swap and Arizona Dyno Chip Turbo Kit 364 whp, 410 wtq @ 4,700 rpm