Originally posted by SVTCANUK:
Here they are.




(In the voice of the Looney Tunes Vulture.)

No,no,no,no,no,no,no,no,no,no,no,no.
UM NO!

Good thing I have an EVTM Paper manual for the 96.
That wiring harness looks just nasty! Could take a full day just to figure them out.

Air box could be re-used silver duct tape over the holes. Trust me it works!

Accordian tube looks ok, don't see any extra holes, just plugged up factory ones. Maybe get a metal CTA intake tube just incase.

The MAF might be ok as it looks like the CNG is behind the sensor. The joining of the 2 parts might be the problem though.

Mark I can't remember, but when we had the LIM off to clean it I don't recall CNG on the fuel rail. Could be a T lower down?

The problem I see is would they have flashed the ECU with CNG codes?
If no wires are going to the ECU harness then we should be ok there.

I belive someone still needs a cruise control cable....

Last edited by chongo; 04/03/04 05:00 PM.
1996 2.5LT V6 Contour ATX My Tour+help/info pics E0 rims, Gutted Pre-Cats,CTA Custom Exhaust & Intake, Diablo Chip.