Originally posted by bluetour: **Sorry, made an error on my above post, I meant to say how to get power to the AMP not the sub. I know the point of the amp is to get power to the sub by bridging the two rear channels, I am constantly mis-using "sub" instead of "amp", I don't know why... So to repeat my query, I want to know how to get power to the amp. If that requires connections at the battery posts or wherever, and what about fuses, etc.
I was going to tap into the factory wire inside the doors. There should be a +/- wire already in there for the factory speaker (I hope, of course, if there's no wire its a good explanation for why the factory speakers sound like such crap) and I was going to hook up the crossover to that. Then all it will take is a little more wire to connect the crossover module to each individual component in each door (tweet and mid).
And just for fun, I am going to repeat my other question too, lest it be forgotten: what kind of speaker wire should I be using? Knu offers a lot of different kinds, and its all greek to me.
As far as speaker wire goes, you don't have to use anything to fancy and remember thinner wire is easier to work with so don't get too low of a Gauge. The kit comes with 12 gauge and that is more than adequate.
