I installed the reverse drum assembly. I have reassembled the unit. All pressure tests come out fine! I did have to reshim based on the new drums installed. Final endplay is a bit tight, but I figured it is better to have it a bit tight than loose! took apart the valve body, cleaned it again ( I just installed the transgo shift pack) Installed new solonoid pack. Assembled valve body to case and installed cover.
I did have to buy the atec tools for installing the drive axle case seals and the tc case seal. These seals are convex on the outside so it is tough installing them. I probably could have found a large socket on the drive axle seals but in no way could I have found a socket large enough for the TC case seal. I guess once I have everything up and running and everything is confirmed ok, I'll probably sell these....
I did install new vss, tss and shift sensor.
This completes the rebuild. I can post a final cost summary if anyone is interested.
Regards,
Bob
