Originally posted by myfastse:
Scott,

You have a brave soul. It is too much work to do this again. I don't think you will have any problems but, I wouldn't trust them. I was talking with Bill and he said that alot of customers didn't know they were TTY bolts. He has people call him all the time with a last minute order for bolts.



Hmmm, I just re-read the service manual and there is no mention anywhere of new flywheeel bolts? Also the tightening procedure is NOT a typical TTY torque, back off, re-torque. I checked under the engine flywheel, transaxle and rear seal replacement procedures and all say the samee thing - so I'll take the chance I guess.


- Install -

2. Install flywheel and eight flywheel-to-crankshaft bolts. Tighten bolts to 112 N-m (83 lb-ft) in a criss-cross pattern.



97 Contour SE MTX K&N 3530, UR UDP, 19# Injectors, mystery mod, FMS wires, Fordchip.com chip, SVT: TB, Flywheel, clutch, exhaust 04 Grand Caravan SXT