Contour Enthusiasts Group Archives Forums General Troubleshooting Duratec: How to replace the oil pressure sender?

Print Thread

Re: Duratec: How to replace the oil pressure sender? #868587 02/11/04 03:43 AM
Joined: Nov 2001 Posts: 1,176 Austin, TX. B btrautman CEG'er
btrautman CEG'er B Joined: Nov 2001 Posts: 1,176 Austin, TX.	I had the exact same problem. I coldn't figure out where all that oil was comming from until I realized the oil sensor was there.....with your previous experience this one shouldn't be all that tought!!!!! An ounce of prevention provides a pound of cure!

Entire Thread
Subject	Posted By	Posted
Duratec: How to replace the oil pressure sender?	brianl703	02/11/04 12:42 AM
Re: Duratec: How to replace the oil pressure sender?	btrautman	02/11/04 01:28 AM
Re: Duratec: How to replace the oil pressure sender?	brianl703	02/11/04 02:45 AM
Re: Duratec: How to replace the oil pressure sender?	btrautman	02/11/04 03:43 AM
Re: Duratec: How to replace the oil pressure sender?	eepals_dup1	02/11/04 01:31 AM

Link Copied to Clipboard