I put the new pcv valve/plugs in the car and after some hesitation it started up. I drove it about about a mile or two when accellerator cable popped off and it stalled out. It wouldn't start up again so I cleaned off the plugs,they were pretty oily and it started and drove home. Started it up today and drove it to get codes at auto zone about a half mile away but scan tool was broken so ive still got no codes. Haven't had a chance to do the test with the pcv sys yet as the car is firing and getting fuel but won't start up again, but now the plugs are clean????? I pulled the intake and it looked like it was blowing a little bit of oil/gas out around the gasket on the rear between the upper/lower intake. I guess I am going to dope the gasket up with some sealant and see if that doesn't fix it up. There was oil i could see in the tube the pcv sits in thoh-