Contour Enthusiasts Group Archives Forums Modifications Forced Induction Vortech Shaft =-(

Originally posted by Rev. Po-Jay:

---

I am gonna try to pin it one more time. We shall see if I can use a better pin this time.

---

Done. Keith used a hardened Grade 8 Set Screw. He was cussing me the entire time!

I drove it home two days ago and there it sits. I am terrified to drive it! Haha. Knock on wood, but it seems quite fine and there have been some rather funny turn of events with the car, as of late... Kinda leads me to think that my Contour luck has changed. I took the car to the Stealership to have a wheel bearing replaced. They replaced my Wheel Bearing, Wheel Hub, Tie-Rod, Power Steering Pump, and ordered me an Idler Pulley... All under warranty! They didn't even mention the 3.0L and barely mentioned the S/C. My Service Advisor is awesome!!!! Anyway, the point is that i replaced the Idler Pulley (they could not as the car was down) and it fixed a weird stalling issue I had.
I hope to run it soon, as i would like a number before she decided to give out again.