i should have pics up soon. u gotta drill. 1 inch hole for each door. i run a 12 gauge and 16 gauge for each front door. if i had to do it again, i'd run all 16 gauge for non sub drivers. i might've gotten away w/ a 3/4" hole then. i wrapped the wiring w/ electrical tape in a clean manner and found the perfect grommets at home depot in the electrical section. they were a tad big so i cut a "slice" of it maybe 2-3 mm out and worked the grommet into place. i have to admit. i love how it came out. it looks so clean. i have to do the rear doors after winter. i'm putting in a vifa 7"midrange and 1" tweet. i want to add an 8"midbass and will switch the 12gauge wiring over to the midbass. otherwise, again, use 16 gauge. the knukonceptz 16 gauge is like have the 12 gauge, really flexible.

look in the front door jambs where the door switch is. go above it above 1 1/2 - 2 inches and slightly to the right (for the left door) and slightly to the left for the right door. then slit the bottom of the stock loom to work the new wire inside. getting the wiring on the inside of the car to the new hole isnt easy but totally worth it.

i'm so freakin' lazy i have 2 rolls of pics to develop of my install to date and showing what u need. i'll do it in the next few days


Hugo AIM:omegazodiac 95 gl & 99 contour svt #1750/2760 my profile pics stuff for sale