Ok, I've done a lot of searches and found some info, but still have some questions regarding Energy Suspension End-Link Grommets (#9.8106). The specs on these grommets are: 1" O.D., 3/8" I.D., and 5/8" nipple O.D. Assuming I can remove my stock end-links from the rear suspension, how do I fit the new grommets into place? Do I need a press or can you use a C-Clamp or something similar? Will these ES grommets even work with the stock setup or is there a better alternative available for repairing the end-links? I'm leaning toward the BAT polyeurathane bushings for the rear sway bar (16mm) and would like to replace the end-link grommets too. I'm getting that annoying "clunk" noise everytime I go over a bump! Thanks.
