Yeah, your headlights came out awesome. After finding out how much they are... I think a couple hours of my time is worth it. Mine aren't even that bad. The one side is damn near done, I could get it better and want to finish it up (I did all of the steps, but just ran out of steam and wanted to get done... had things to do) but I want to know how you people are doing this in an hour. I folowed the directions to a "T" and after about an hour on one light... I still wasn't totaly done... it was a lot better, but that layer of coatings on the light is a total PITA to get off with 1500 sandpaper... let me tell you. Any other advise on how to get these done faster than I am now with the same results... I don't have a problem spending time, but sanding one square inch for over 10 minutes to get rid of the UV coating was a bit rediculous.
Advise here is greatly appreciated guys! Thank you!
