CV joint roller bearings

Print Thread

Re: CV joint roller bearings #758001 09/30/03 04:20 AM
Joined: Oct 2002 Posts: 2,408 R Rogerm60 Hard-core CEG'er
Rogerm60 Hard-core CEG'er R Joined: Oct 2002 Posts: 2,408	Originally posted by trek7000: Is there any way to tell if the roller bearings came off the tri pod on the axel shaft with out removing the cv boot? I installed camber kits on my car and the axels popped out a couple of times.everything went back together ok.How much play should there be in the cv joint when you spin the tire? What camber kits??? How much offset??? How much are you lowered??? If the knuckles are too far from the tranny case you will continue to have this problem. "Those who cannot remember the past are condemned to repeat it" -George Santayana

Link Copied to Clipboard

Contour Enthusiasts Group Archives Forums Modifications Transaxle CV joint roller bearings