Contour Enthusiasts Group Archives Forums General Troubleshooting 1/3,000ths of an inch enough warping to...

Print Thread

Re: 1/3,000ths of an inch enough warping to... #756792 09/26/03 03:07 PM
Joined: Jul 2000 Posts: 2,382 Kansas City,MO,USA,Earth, Terr... N Nate'sTour Hard-core CEG\'er
Nate'sTour Hard-core CEG\'er N Joined: Jul 2000 Posts: 2,382 Kansas City,MO,USA,Earth, Terr...	Can't the head be ground down flat again? Sounds like they need to take less than a hairs width. Machine shop?? "Fear is the little death." Muadib.

Entire Thread
Subject	Posted By	Posted
1/3,000ths of an inch enough warping to...	Mystang	09/26/03 11:15 AM
Re: 1/3,000ths of an inch enough warping to...	horseydug_dup1	09/26/03 11:52 AM
Re: 1/3,000ths of an inch enough warping to...	procyon_dup1	09/26/03 04:49 PM
Re: 1/3,000ths of an inch enough warping to...	BStoneMega	09/26/03 05:49 PM
Re: 1/3,000ths of an inch enough warping to...	Mystang	09/26/03 07:05 PM
Re: 1/3,000ths of an inch enough warping to...	Stevedrivr	09/26/03 10:53 PM
Re: 1/3,000ths of an inch enough warping to...	luvinmycontour	09/26/03 10:57 PM
Re: 1/3,000ths of an inch enough warping to...	mrspindlelegs	09/26/03 01:54 PM
Re: 1/3,000ths of an inch enough warping to...	Nate'sTour	09/26/03 03:07 PM
Re: 1/3,000ths of an inch enough warping to...	BStoneMega	09/26/03 04:22 PM

Link Copied to Clipboard