Originally posted by beyondloadedSE:
couldnt you just save yourself some time and use the 3L oval port LIM and then just bore the svt UIM to match, instead of boring both the SVT LIM and UIM?


You seem to be missing the Entire point that the secondary plates ARE IN the LIM...

It would be kind of hard to use the dual runner manifold system properly without them eh?


Mixing and matching would serve no purpose. Your best bet is to use a complete set of either. Be it the Oval port setup and sending the UIM to Extrude Hone (ala the ST220) or using the dual runner setup (In my case a TH UIM and modified LIM with secondaries)

~~~

BTW - Where are those pictures svttour???

2000 SVT #674 13.47 @ 102 - All Motor! It was not broke; Yet I fixed it anyway.