I've just picked up some R rotorz (ebay specials) and some Mintex A/F Street Pads. The front went together without a problem, but the rears are giving me a hard time.
I can't seem retract the rear piston far enough for the capiler to fit back over the rotor. I believe I'm screwing the piston in as far as it will go. I've also checked the fluid level in the master cylinder along with trying to bleed the caliper slightly.
Now I'm beginning to think either the rotor or pads are too thick. Both claim to be OEM size, made to fit, no modification is needed.
As of now, I'm forced to run one old pad with one new pad until some wear takes place. Does anyone have any suggestions or know where I can find the thickness specs on these parts? Thanks in advance...
