i think it would look good but u have to remember that the middle part of the m3 bumper sticks out more then the rest of the bumper. that is going to be the major problem with this project. i see major problems from keeping it from cracking if its not later molded in full state off the press.
if your planing ot do this with polyflex, fiber glass i see it cracking from minor things. basically im saying its doable but its gonna be hard from keeping it from cracking down the center. and mike you wont beable to cover the se bumper witht the m3 bumper like i did with the svt bumper because the m3 bumper is shorter. so there u go.
Experience is the worst teacher; it gives the test before presenting the lesson.
Why do you need the cats when u have dogs
04 WRX - TOTALED 3-5-05
Previoius Owned: 96 Contour LX with svt kit
