I ran two wires from the footwell lights to power the curb lights I re-contented from a Mystique LS/olderGS by cutting a slot with a small hole hole in a rubber grommet so that the wires would be in the center of it. I re-installed the grommet and it fits without any trouble. The grommet was already there from the factory. Take a look on your car's front doors near the connector for the factory wiring.
------------------
'98.5 Mystique GS ATX/re-contented door lights/K&N Filter/Energy Suspension Sway Bar Bushings/Mintex Street Pads/high-beam bulbs in low-beams/Pioneer DEH-P3100 receiver/Pioneer TS-A6855's in all doors
[This message has been edited by 4cylmys (edited February 19, 2001).]
