First, buy the removal tool. My kit came with four individual pins with loops on the ends. Notice that the pins are notched. When you insert the pins in the holes on the rt side of the radio...make sure the notches are facing the driver door. The opposite is true when you install the pins into the holes on the left side of the radio...the notches should face passenger door. Insert the pins until they kinda click into place. Now insert one finger into each one of the loops/hoops...whatever. Without trying to pull the radio towards you yet...spread the loops apart. Sorta as if you were trapped in an elevator and were trying to pry the doors apart. While prying the loops outward (maybe a 1/4" on each side), pull the radio towards you. If your wiring harness is long enough and/or not strapped down somewhere, you should be able to pull your radio out far enough to un-clip the radio from the harness. Mine wasn't that easy...oh well. Hope this helps you. FYI...I bought my DIN removal tool from
www.mcmelectronics.com for about $7.
