get two coat hangers and cut at each end before it begins to bend. then, bend each peice you cut so that it fits straight into the holes on each side of the radio. the ends of eachkey that you have made, need to be cut after you have dont this so that the ends push the tabs which hold the stock stereo in at the same time. now, put one key on one of the sides and push slightly in towards the stereo, you should feel a click of some sort. DO NOT push too far, that will break the tab and you willl have to cut the stereo in half or something. now that it is firm and in place, pull a little so that the one side pulls out a little. you will know when this happens. put the other key in and repeat, but when you go to pull the side out, you will pull the entire stereo out. hope this helps!
