Originally posted by techme:
The door grab handles where the easiest. Get a very thin, flat screwdriver(not quiet as skinny, brittle and sharp as a jewlers). Carefully penetrate the screwdriver blade into the bottom crack between the handle and the insert. Carefully 'pry' the insert out. The two hard things are trying not to leave a 'bur' on the grab handle (I did and had to trim with a sharp knife) and finding the right location to insert and pry to get the most efficient pull out.
there is an easier way if you don't have a thin flat screw driver, if you have a small phillips of flat screw driver, there is a whole under neither the handle, push the screw driver up there, and push towards the door, then the piece should pop out a bit, then pull it out.
95 SES Sold
99 SE Sport Sold
99 SVT T-Red Tan Interior. K&N, Magnecors, 19' Theorys, And some audio stuff.
| 
