Register Log In

Contour Enthusiasts Group Archives Forums Modifications Duratec Performance EEC-V programming

Print Thread

Re: EEC-V programming #707096 07/31/03 09:02 PM
Joined: May 2000 Posts: 32 Somewhere, MD S Steve Bassen_dup1 wannabe-CEG'er
Steve Bassen_dup1 wannabe-CEG'er S Joined: May 2000 Posts: 32 Somewhere, MD	I'd contact Mike Grover first, but last I heard the Contour's PCMs are supported by the TwEECer. ECC-V support is 90% implimented, and should be 100% supported by the time the final v1.20 of the software is available. Just an attack, not an observation.... 04 House 04 Gixxer 600

Entire Thread
Subject	Posted By	Posted
EEC-V programming	Andrew Paule	07/30/03 02:21 AM
Re: EEC-V programming	Keyser Soze	07/30/03 02:28 AM
Re: EEC-V programming	GreenNuggs_dup1	07/30/03 01:31 PM
Re: EEC-V programming	tw0wheelin_dup1	07/30/03 04:34 PM
Re: EEC-V programming	DemonSVT_dup1	07/31/03 08:48 PM
Re: EEC-V programming	Steve Bassen_dup1	07/31/03 09:02 PM
Re: EEC-V programming	tbirdjayc	07/31/03 09:24 PM
Re: EEC-V programming	Lance Kinley_dup1	07/31/03 09:48 PM
Re: EEC-V programming	Steve Bassen_dup1	07/31/03 09:56 PM
Re: EEC-V programming	DemonSVT_dup1	07/31/03 10:47 PM
Re: EEC-V programming	DemonSVT_dup1	07/31/03 10:48 PM
Re: EEC-V programming	Steve Bassen_dup1	07/31/03 10:58 PM
Re: EEC-V programming	tbirdjayc	08/01/03 03:33 PM
Re: EEC-V programming	Qbert_dup1	08/01/03 04:03 PM
Re: EEC-V programming	DemonSVT_dup1	08/01/03 05:02 PM
Re: EEC-V programming	rick272	08/02/03 08:25 PM

Moderated by GTO Pete

Link Copied to Clipboard

Powered by UBB.threads™ PHP Forum Software 7.7.5