I thought about putting it on the dyno once, there is only one within 2 hours of my house. I rode by one afternoon and stopped in, the guy builds turbo dsm and honda cars. He looked under my hood and started laughing his butt off. Pointing out to his buddy my extra injectors (saab cold start injectors hooked up to pressure switches) My engine bay isn't show standards but its semi-clean install and fabrication, plus I did it all for under 3000. (Car included) He commented multiple times about my primitive setup.. So I wasn't too hot to have him put it on the Dyno, though I could have just to prove him wrong.. Oh well start on the engine again (if I did detonate and melt a piston). Make it stronger. I think this time I will use bigger injectors and adjustable fuel pressure regulator. Also looking to add piston oil squirters.... That is if I have to start over again.
Ryan
