Today on the way to my office when I was trying to turn right, my 98 4cyl Contour had a problem. The steeling wheel just stuck when the car had not finished the turn. I was pushing the brake a little bit at the moment since it was a sharp turning and I didn't slowed down enough before I turned. I stop the car. The engine was still running but I cannot drive forward or backward, nor could I turn steeling wheel. I notice the Check Engine light and the Engine Oil Pressure light were on. I turned off the key and started the car again. No light on and I can drived to my office Okay.
Has this happen to you guys before? Should I do anything about it? Thank for any response.
