Hey,
Sorry it took me a bit to get back. For the cam alignment tool, I went to Lowe's and got a piece of 3/16" flat steel bar. It was like $5 and I just hacksawed off a piece about 8.5" lond. I just put an open end wrench on the cam hex to hold it still. I only had to loosen the exhaust cam sprocket. Make sure you reset the vct. They almost always stop in the retarded position. I bought a single T55 and T50 at Autozone for $4 each and they were 3/8 drive.
See Ya'll
Ray
