Quote:
Originally posted by Rob Shaw:
What is your MAF voltage @ idle now that it is clean and working better?
About 1.0, and 1.8 at 3000 RPM in neutral -- 0.1 higher than before in both cases.

Now I want to voltmeter the throttle position sensor. See, I was installing the switch for the e-RAM, and just when I had it just about finished, after fabricating a specially shaped plate to mount it on and everything, their cheap switch broke. So now I'm thinking of maybe making an electronic switch that monitors the throttle position sensor, instead of replacing the mechanical switch with a similar one.

96 GL Zetec ATX, white with pinstripe, nickname " Sam Smooth "
mods so far: CTA intake with homemade heat shield, KVR drilled front rotors & carbon pads w/ 500° fluid
planned mods: exhaust (want to keep it quiet), e-ram (awaiting installation), diablo chip
involuntary mods: compression increased after head gasket failure