Here's the 95 service manual procedure:
Cooling Fan Motor, Fan Blade and Fan Shroud Assembly, Electrical
WARNING:
TO AVOID THE POSSIBILITY OF PERSONAL INJURY OR DAMAGE TO THE VEHICLE, DO NOT OPERATE THE ENGINE WITH THE HOOD (16612) OPEN UNTIL THE FAN BLADE (8600) HAS BEEN FIRST EXAMINED FOR POSSIBLE CRACKS AND SEPARATION.
Removal and Installation
1. Drain engine cooling system as outlined.
2. Disconnect battery ground cable (14301).
3. On 2.5L engine equipped vehicles, disconnect wiring harness connector from A/C cycling switch (19E561).
4. Remove main wiring harness retaining push pin from fan shroud (8146) and disconnect main wiring harness from retainer brackets located at top of fan shroud.
5. Move main wiring harness aside.
6. Remove cooling fan wiring ground cable from RH front fender apron (16055).
7. Remove upper radiator hose (8260) from radiator (8005).
8. On 2.5L engine equipped vehicles, remove radiator overflow hose (8075) from radiator.
9. Remove transmission oil cooler tube from oil cooler inlet fitting (if equipped).
10. Raise vehicle on hoist. Refer to «Section 00-02».
11. Remove lower radiator hose (8286) from radiator.
12. NOTE: Loosen transmission oil cooler tubes while holding radiator connector with back-up wrench.
Remove oil cooler tube from oil cooler outlet fitting on radiator (if equipped).
13. Disconnect A/C clutch field coil at wiring harness connector.
14. Remove transmission oil cooler tubes from retaining bracket located at front of front sub-frame (5C145) (if equipped).
15. Remove transmission oil cooler tubes retaining bracket from front sub-frame (if equipped).
16. Support fan shroud, radiator and A/C condenser core (19712) with a suitable jack stand. Remove lower radiator supports (16138) from front sub-frame.
17. Remove two retaining bolts for A/C condenser core from brackets at bottom of radiator.
18. Position jack stand aside and carefully remove the fan shroud and radiator as an assembly.
19. On bench, remove fan shroud from radiator.
20. To install, reverse Removal procedures. Tighten nuts retaining fan shroud and bolts retaining A/C condenser core to radiator retainers to 2.7-5.4 N-m (24-48 lb-in). Tighten lower radiator support retaining bolts to 8-11 N-m (71-97 lb-in). If equipped, tighten transmission oil cooler tube to fitting to 24-31 N-m (18-23 lb-ft). Refill cooling system as outlined.
