My cousin and I decided to install my DMD.
Everything was going great until my cousin took of the original crankshaft pulley bolt and used the puller without it. This stripped the threading inside the crankshaft pulley.
I went to Autozone to rent their equipment in hopes that I could re-thread the crankshaft, but the tool isn't able to get in and start making a new thread. Probably because it has been worn down from over-use.
Any other suggestions would be greatly appreciated.
If I was Bruce Banner, I would have turned into the Incredible Hulk about 300 times by now.
Please help me before I loose it!!!!
Thanks
