|
|
Joined: Dec 2001
Posts: 6,910
Hard-core CEG'er
|
Hard-core CEG'er
Joined: Dec 2001
Posts: 6,910 |
Originally posted by brapple:
Elky and CobraR,
I will be heaing out to get the Water Wetter for you shortly, will post again when I get back
all set, check your pm's
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
|
|
|
|
|
Joined: Oct 2001
Posts: 8,445
Hard-core CEG'er
|
|
OP
Hard-core CEG'er
Joined: Oct 2001
Posts: 8,445 |
NY State Trooper: So what makes your car so special to have SVT all over it?
Me: Er...It was made by Fords SPECIAL Vehicle Team?
|
|
|
|
|
Joined: Mar 2001
Posts: 7,431
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Mar 2001
Posts: 7,431 |
Originally posted by zgendron:
It takes you through Worcester, but it's faster.
<tightwad>
And much cheaper too! Thumbs down to Pike hikes!
</tightwad>
|
|
|
|
|
Joined: Jun 2001
Posts: 2,299
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Jun 2001
Posts: 2,299 |
Originally posted by ElKy:
jay, i did most of the yardwork yesterday, and will be finishing it up today.
so if you want to get the jet ski un-winterized, go right ahead.
if you could grab more of those lint free rags, that would be great
I had a change of plans today and I got the jet ski going today instead. I left un-treated gas in it all winter so I was nervous I'd have the daunting task of removing the exhasut system to gain access to take the carbs off for cleaning. Ski Doo tech manual estimates that job at 12 hours with 8 hours for access.
Lukily there was no problem with stale gas. The only problem was a dead battery. A day on the battery charger fixed that. It fired up after just 5 seconds of cranking after sitting for over 6 months.
Now all I have to do is wait till the resivor or the near by river warms up a little to take it out for its first ride of the season.
Looks like friday will be a day for a very much needed car cleaning. Its been months since the last time I gave it a cleaning.
I'll see what I can do for the lint free rags. I'll try to get the same kind as last time. Dupont Sontara wipes. If not them then I'll bring some clean room certified lint free wipes, these are actually made by a comapny based somewhere in MA.
I feel sorry for the people who don't drink. When they wake up in the morning, thats the best they're going to feel all day - former President Lyndon B. Johnson
|
|
|
|
|
Joined: May 2001
Posts: 8,770
Smurfette
|
|
Smurfette
Joined: May 2001
Posts: 8,770 |
Originally posted by ElKy:
ok peeps, i talked to my cousin.
he will be getting me burgers, dogs , and the famous steak tips.
which is a good thing cuz i have been working on the marinade for a while now!!
make sure you put a little donation box at the door so we can chip in for some of the yumyums 
Kim
1995 Contour GL
Needs less "needs more"
|
|
|
|
|
Joined: Nov 2002
Posts: 1,272
Hard-core CEG\'er
|
|
Hard-core CEG\'er
Joined: Nov 2002
Posts: 1,272 |
Hmmmmm......I think I'll bring some of my "world famous" Teriyaki steaks made in a Maple Sugar/teriyaki Marinade!! Elky, what else should we bring?? Plates, napkins, anything??? Oh, thanks for the directions, people!!!
A1C Hodges, Christopher Active Duty USAF Sheppard AFB Texas;Westover ARB Chicopee, MA
NECEG "Troll"
formerly owned 2000 SVT Contour, with all kinds of goodies;)
|
|
|
|
|
Joined: Jun 2001
Posts: 1,047
Hard-core CEG\'er
|
|
Hard-core CEG\'er
Joined: Jun 2001
Posts: 1,047 |
Originally posted by JSmith:
Steve: For your DMD install, do you have a new bolt and washer? Would you also like to change the front crankshaft seal while we're at it? If you don't have one of them let me know, the local dealer here has had them in stock every time I've gone to get one. They're about $6.
I got the bolt and washer when I got the DMD. I haven't ppicked up the crank seal yet though. If you could pick one up that would be great. If you can't just let me know annd I'll head to the dealership to see if they have any. One important question I forgot to ask was does anyone have the "puller" that we need? Was it you that had it?
Steve
Help Support MS research
2003 SAAB 9-3 Vector
2002 Explorer Limited
Former cars '98 T-Red SVT and 2000 Silver Frost SVT
|
|
|
|
|
Joined: Jun 2001
Posts: 2,299
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Jun 2001
Posts: 2,299 |
Originally posted by cruises8:
One important question I forgot to ask was does anyone have the "puller" that we need? Was it you that had it?
I believe that Elky has one, since it was his that we were using when we did the installs. I also have a puller.
He also has the long bolt that is used to pull the DMD onto the crankshaft, while the bolt I have is a home made one that is 2 old DMD bolts welded together.
I feel sorry for the people who don't drink. When they wake up in the morning, thats the best they're going to feel all day - former President Lyndon B. Johnson
|
|
|
|
|
Joined: Dec 2001
Posts: 6,910
Hard-core CEG'er
|
|
Hard-core CEG'er
Joined: Dec 2001
Posts: 6,910 |
Weather looks good for now
- 95 Mystique LS - Zetec/5spd
- 99 Contour SeVT Sport - Duratec/5spd
Official NE-CEG Contour/Mustang Family
|
|
|
|
|
Joined: Oct 2001
Posts: 8,445
Hard-core CEG'er
|
|
OP
Hard-core CEG'er
Joined: Oct 2001
Posts: 8,445 |
as for plates and napkins and such..we have that covered.
so food, munchies and beverages can be brought if you like.
NY State Trooper: So what makes your car so special to have SVT all over it?
Me: Er...It was made by Fords SPECIAL Vehicle Team?
|
|
|
|
|
