O-k..been there done that.
The fuel injector hats just unclip...
It's easiest to use a fuel line tool and disconnect the fuel line from the fuel rail. Unbolt the LIM...disconnect the IMRC. Now here's the hard part. The wiring harness kinda forms a tent over the LIM. Carefully pull up on the harness and snake the LIM out from underneath it. Now...the fuel rail has 3 or 4 small bolts holding it onto the LIM. Remove them. The fuel rail will be really stuck onto the end of the injectors via the unjector O-rings. Take a deep breath..and pull up on the rail evenly until it pops off. Other than the 3 or 4 bolts holding the rail on, there aren't any retaing clips or anything to worry about. Some of the injectors will remain in the LIM..some will remain attached the fuel rail. But once they are seperated you can remove them all from which-ever and lay them to the side. Remember to oil the O-rings when you reinstall.
Hope that helps...
