Originally posted by chknhwk:
What's the status on the Tweecer? Isn't it close to fruition?


Well it works for only a couple of our PCM codes.

However for 100% coverage they would need to have access to 100% of the PCM's. (I.E. have folks send it to them so they could copy the binary off it)

Also they are currently hard at work writing all the code for the RT version of all their covered codes. (I.E. little time for hammering out each individual processor strategy )

I can tell all the XGT1 folks for the most part they only have 2 areas left to figure out though.
1 large (rev limiter ) and 1 minor (knock sensor)
Pretty much every thing else is fairly well accounted for. A lot accounted for to the extreme (definitely a STEEP & possible Dangerous learning curve)

2000 SVT #674 13.47 @ 102 - All Motor! It was not broke; Yet I fixed it anyway.