pakrat.....FYI for you.......if your gonna do the washer sprayers....you'll notice they should go behind where the frame is.....here is a good how too on drilling through the frame...its a hood pin install but its the same thing.
when i did my pins i found a place on the hood so i did have to go through the frame, but for the washers i don't think there is a way out.
if you look at the top really close...you can see where the go, there is a VERY small dip/pit in the hood...you wouldn't notice unless you were looking.
So i would drill(small bit) down at those spots so not to mess up the clear coat drilling up. then use the hole bit on the frame underneath. then use the drill from the top and make the holes big enough for the sprayers..start will small bit and keep working up th the size you need.....drilling the large hole into the frame will give you room to work from the bottom...and you could probably drill a hole on the passenger side and route the hose throught the frame instead of attaching it like on the stock hood.
here is that site
http://www.venommotorsports.com/library/hoodpins.asp
