Do you remember seeing the prototype of the streetflight CAI...well its basically the same.Actually the tubing that i used,joins almost exactly at the same spot except it doesn't connect directly to the valve cover breather like the street flight did(it was welded or something) anyhow.....Directly beneath the MAF is that main bolt that is attached to the subframe(if thats what you wanna call it), its the same place that the CTA motorsports intake attaches to. I had to make a little bracket to fit but anyone with half a brain could do that.As far as the fender piping goes...There is a 90 degree elbow that goes directly down(its a lot of pipe too into the bumper about 6 inches from the fog light hole. So far thats where i have stopped. I need to find a way to secure the intake in tight...i don't want the thing bouncing up and down everytime i hit a bump. Its going to have great results i think. If you look under your car, behind the drivers side fog you will notice a square cut out that allows you to see up inside. Well the filter sits pretty close to that...almost directly over it. Ill help ya if you really need it