Originally posted by jthursby: I got my second one Friday. Thats all I'll say here.
Jim
Okay I changed my mind. Lets just say that my SECOND system fit worse than the first! When I mounted the front pipe with the mufflers attached the tips are 8 inches off the bottom of the bumper! You should see the pictures! They hang down at a 70 or 80 degree angle. WTF? It wont fit without a sawzall and a tig welder. I'm royally pissed now! Twice I've had my old exhaust off only to have to reinstall it again. I should have done a straight dual setup like DemonSVT did. Would have been faster (by far) and at least done correctly. I might have enough parts to build a decent system but WTF? why should I for $580.00? I fully expect bullshizit about Brullen taking this crap back, but we'll see. Personally I'm not enthused about Brullen's quality control either. The first system had a washer welded on the hanger rods to stop the isolator from sliding about, there aren't any on the new pipe. And so much for an all stainless system as the flanges are mild steel. All of them. Brullen would have to go above and beyond to make their company shine in my eyes at this point.
Jim
"Every normal man must be tempted at times to spit upon his hands, hoist the black flag, and begin slitting throats".--H.L. Mencken
Bumper sticker,
OXYMORON #65 - Liberal Thinker
I fully expect bullshizit about Brullen taking this crap back, but we'll see. Personally I'm not enthused about Brullen's quality control either. The first system had a washer welded on the hanger rods to stop the isolator from sliding about, there aren't any on the new pipe. And so much for an all stainless system as the flanges are mild steel. All of them. 
Brullen would have to go above and beyond to make their company shine in my eyes at this point. 
