Originally posted by Bridge:
Originally posted by mcon99:

why would you pay someone to install this

do it yourself it is an easy job



Well I'm not very knowledgeable when it comes to motor mounts, but wouldn't you need to get the motor off the old mounts to replace them with new ones? And that I wouldn't be able to do without the proper equipment.

The top two mounts do a good job of holding up the motor so there really isn't a lot of tention on the motor mount at the bottom ( Front one we are talking about)If you had a set of ramps that you use for oil changes then you could do it with them some tools and your tire jack. Use you tire jack to relieve little or no pressue from the mount and remove. You will really only need the jack for when you put the bolt back in to the new mount. The old one is so worn that it really just sits in there doing nothing.

So how much do the full urethane mounts decrease wheel hop by? A [censored] load. I went from mad crazy wheel hop to no wheel hope most of the time.

Also where exactly are the motor mounts located under the hood? The mount is under the front of the motor. It is mounted to the radiator support I believe. I hope this has been helpful and answered all you questions. P.S. worth every penny.

Later,
Eric

Just a Plain SE. AKA Big Country I maybe path914's B**** now, but wait until he needs his clutch done. We will see WHO is WHO's B**** then!