Yes. Pads (front and rear) would be $90 shipped. But be 100% sure you aren't below the min thickness on the rotors (22mm on the fronts and 18mm on the rears)). To measure them it you should use a set of calipers.

Sometimes rotors "look" good, but they are actually to thin. That's what I saw on all the Contours I did brakes on.

The problem is that the factory pads are super aggresive on the rotors and wear them out real quick. Plus they have poor heat dissipation properties and fade very easily.

2000 SVT Turbo 295hp/269ftlb@12psi #1 for Bendix Brakes Kits! Knuckles rebuilt w/new bearings $55 AUSSIE ENDLINKS $70 Gutted pre-cats $80/set A lack of planning on your part does not constitute an emergency on mine!