Contour Enthusiasts Group Archives Forums General Troubleshooting Climate Control Problem

OK kids....here is a probable cause.

Located under the dash, near the center console on the driver side by the pedals, is a vacuum motor that moves a lever that changes where the air vacates. What can happen is this lever pops off of the arm that moves the vents. Look under and in that location described above. Adjust the HVAC controls and see if you see the arm move. You should see the this silver cannister thing have an arm move in and out relative to the moving of the HVAC controls. You will probably notice nothing attached to it. This is your problem.

Near by will be a black arm. Find the selection where the silver cannister has its arm out the fullest. Pop the black arm's piece back into the hole on the vacuum motor and that should fix your problem. If you put it on and it comes back off, you may want to find a small ring clip that you can put on the end of the back arm.

L8R
Rich