Today I decided to install the SVT upper I had and change my plugs and wires and maybe crack the secondaries. All went well until I was installing the bolts for the upper.
I inserted a bolt into position 1 as per the chilton manual. I tightened it slowly with a torque wrench and "snap"...the bolt broke in half. Just a little part of it is above the lower manifold the rest is stuck below. The words that came out of my mouth I cant post here
I continued the install and finished up due to the fact that I was so tired already. Now my manifold sits with only 5 bolts attaching it to the lower. Will this cause issues if I leave it for a while till I figure out what to do?
